In this month I have been working and improving the website adding detail to the IR circuit and giving information about me in the meet the team. The website needed to be constantly updated to represent new and information out there and constantly update in information. I have continued being the team leader and at the end I did a reflection to show what I did and what was going on as I was team leader.

We then moved onto the next section of the micromouse design which was designing the PCB and to make sure everyone in the group know it works we all were given instructions on how to use the software proteus. This software is needed for our PCB design which will then cut out and then we will solder on the board our circuit. This design was done by Juan and llewellyn which and then I chose whoses board is going to be used for the micromouse.

I also completed the IR circuit by adding a second sensor, this give a second eye for the robot but we needed so we can tell that if it is going left or right or even do 180 degrees. The IR circuit needed to be spot on for both as even if it a little of it even work on as a result